You may use a piece of furniture exactly how you need it by using gas struts, often referred to as lifters, hinges, or gas actuators. For example, the tops of kitchen cabinets with a horizontal orientation are where gas struts are typically installed.

Therefore, unlike traditional furniture hinges, it is unnecessary to tilt the entire door sideways to access something within such a cabinet. Instead, raise the front end (or downwards in base units).

What are the purposes of Gas Struts For Cabinets? How should gas struts for furniture be measured and installed properly? The information is provided in the post below.

What Are The Purposes Of Furniture Gas Struts?

•    Gas struts are a well-liked furniture accent. They are utilized in a variety of furniture styles. Thanks to the gas system, you can support the front without doing so. When you tilt the cabinet, its front portion will remain open steadily, providing excellent comfort while you do your daily tasks.
•    Most frequently, but not exclusively, gas cylinders are utilized for kitchen furnishings. They can also be found in ceiling-mounted cupboards, bedroom and bathroom furniture, and room dividers.
•    Bar cabinets are common places to find them. They are very helpful in the under-floor and handy in top cabinets when hinged from the top. They make it much simpler to get to the stuff you need in any situation.
•    The front panel can be opened and closed freely with these gas lifters, and they can hold it in place anytime. There are several comparable goods, but pneumatic jacks are arguably the most well-known.


How To Install A Gas Strut?

Please consider all health and safety concerns and precautions when installing the gas struts since they can be dangerous.

It’s time to install the gas strut you’ve chosen from our selection that will fit your door.

1)    Carefully prop open the door using a door stopper as the first step. Most hinged doors will have this at a 90-degree angle to the closed position.
2)    The gas strut chart will look at a length at 90° (P) measurement. This separates the hinge’s pivot point and the top gas strut mounting point.
3)    At this stage, mount the top of your gas strut. As previously illustrated, it is crucial to attach your struts with the larger tube at the top.
4)    After the gas strut’s bottom has been mounted, swing it to the side of the body as illustrated below. Use it to establish the location of your bottom mounting point. At this point, mount the gas strut’s bottom.
5)    It should be okay to remove the prop keeping the door open once the gas struts have been installed. Your door’s weight ought to be supported by the gas struts.
6)    Change the gas struts to match the door’s weight. Due to the flexible nature of Co-gas Mac’s struts, you can lower the pressure until the weight of your door is accommodated.

Remember to apply an equal number of pulses to your door’s gas struts. Check the struts frequently to see if the proper pressure has been obtained.

Also, you can Contact us to learn about Adjustable Cabinet Legs, and Wardrobe Sliding Door Wheels.


Concealed Cabinet Hinges | Kitchen Cabinet Hinges | Heavy Duty Drawer Runners | Ball Bearing Drawer Slides  |  Kitchen Cupboard Hinges | Full Extension Drawer Slides

By Team